At present, there are some problems in China's kitchen machinery industry, such as less varieties of products, not strong integrity of vegetable cutting machine, weak scientific and technological development ability, unstable performance and so on, and there is a big gap between China and foreign kitchen machinery industry.Therefore, most of the domestic food production enterprises are more inclined to introduce new or used kitchen machinery products from abroad.The introduction of foreign kitchen machinery products dicing machine has become an inevitable trend at this stage.But this is not to say that China has no good central kitchen machinery enterprises.
Lighting and cleaning of vegetable cutting machine room are very important to ensure the safe operation and maintenance of vegetable cutting machine.Because the furnace staff in order to ensure the normal supply of steam equipment, at any time to monitor and adjust the maintenance of every part and part of the machine, such as no good lighting conditions, the operation of the staff can not be carried out or the work is not safe.On the other hand, the equipment is not clean, which is easy to cause rust and hidden dangers. At the same time, some faults are not easy to be found in time, which affects the operation of the vegetable cutter.For example, because the ground and trench of the vegetable cutting machine room have not been cleaned for many years, frequent water leakage has not been found, so that the flue of the economizer is blocked and the equipment is corroded, thus causing the furnace shutdown accident.Practice has proved that the more dark, wet and dirty the place, the more prone to failure.Therefore, clean and tidy and good lighting have become an important prerequisite for the safe operation of vegetable cutting machine.
All the maintenance work of the vegetable cutter must be carried out when the power supply is cut off.
1. After each use, clean the machine carefully, do not touch the conveyor belt and pressure belt with sharp instrument, and do not spray water pipe.
2. If the conveyor belt and the pressure belt are found to be loose and slippery, the tightening bolt or spring pressure should be adjusted to the appropriate position in time. The tension or pressure at both ends of the belt should be basically equal, otherwise the conveyor belt or the pressure belt will run off.
3. Check the wear condition of triangle belt, and adjust and replace it in time.When the triangle belt is loose, loosen the bolts of the tensioning mechanism to adjust and tighten the bolts after the triangle belt is tensioned.
4 Each shift to the ratchet, gear, sprocket oil once, choose 20 oil, each time the amount of 10 drops is appropriate, bearing grease, according to the use of appropriate amount to add and replace, use calcium grease grease.
